The check point of the bite taking

It seems that it said first, a bite taking by the occusal rim is very difficult work.
Therefore, say.
You must not give up.
Soften the occusal rim of the lower jaw equally in the hot water, and do a bite taking.
Tell a check point on the model at the time of that.

Before that....

1) Write a median line to the working model.

It begins from here.
Without this, all the checks after this can't be done any more.
Let's do this surely.

2) Confirm that the median line of the occusal rim of top and bottom which did a bite taking is correct.

3) Settle an occusal rim in the working model of the lower jaw, and it adapts it to the occusal rim of the upper jaw.
Then, confirm the agreement of the median line.
At the same time, confirm whether there is a deviation with the hamular notch and the retromolar pad

4) Settle an occusal rim in the working model of the upper jaw, and it adapts it to the occusal rim of the lower jaw.
Then, confirm the agreement of the median line.
At the same time, confirm whether there is a deviation with the hamular notch and the retromolar pad

5) See it from the side.The occlusal plane of the upper jaw hits 1/2 of the retromolar pad, and confirms that it is passing (in other words, the same position).

The check of the bite taking of the complete denture which you must do on the model is completion in this.

Well, let's try it from the next patient.